-(1).png)
Special Features:
- solvent free,
- extra long working time,
- suitable for chair casters,
- high initial strength,
- can be walked on immediately,
- For radiant heated floors,
Subfloors
All surfaces shall be dry, smooth and level. They must be structurally sound, solid, well fastened, clean and free from dust, oil, grease, paint, wax, old adhesive. Check for curing and parting compounds, surface hardeners and sealers which are known to interfere with the adhesive bond to concrete, as well as loosely bonded toppings, primers or any other deleterious substances that may prevent or reduce adhesion. Prior to the installation check any subfloor properly according to NWFA guidelines. Any irregularities of the subfloors may telegraph through the cork flooring; make sure the subfloor is evenly smooth and level.
Application
Stir adhesive for cork Wakol D 3540 well before use. Spread adhesive evenly and uniformly on the back of the tile and the subfloor using the recommended roller. The tiles can be coated and allowed to dry in advance (maximum 24 hrs. before installation), however the substrate must be coated at the time of installation. Be sure, that tiles and subfloor are completely covered. Allow to dry until the adhesive for cork is clear, dry to the touch and slightly glossy. If you are unsure about the coverage a second coat may be applied once the first coat is dry. Set tile carefully in place and use a rubber mallet to secure the tile into the adhesive. Install tiles within 3 hours after the floor is coated; tiles covered in advance must be installed within 1 hour. If installation will take more time, an additional coat of adhesive can be applied over the first coat. Clean tools and equipments with water before adhesive cures.
Disclaimer
Do not use cork adhesive glue Wakol D3540 below grade with excessive moisture or hydrostatic pressure. Acclimatize materials during cold periods properly. Do not use WAKOL D 3540 for vinyl cork flooring. The responsibility of the suitability of the adhesive for each individual case cannot be assumed, as the manufacturer has no influence on the proper application of the adhesives by the installer and or contractor. The directions for use were established on the basis of research, experience and tests believed reliable. Any liability on the part of the seller cannot be derived therefrom, verbal information is subject to written confirmation.
Azok a vásárlók, akik ezt a terméket vásárolták, szintén megvásárolták
